Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Side-stand removal and installation

Removal

  1. Support the motorcycle with a jack or wooden block.
Caution

  •  do not support the motorcycle with the exhaust pipes.
  •  Make sure that the motorcycle is supported securely.
  1. Remove the side-stand as shown in the side-stand construction. Refer to “side-stand construction” .

Installation

Install the side-stand as shown in the side-stand construction. Refer to “side-stand construction” .

Pillion footrest construction
Pillion footrest Spring Ball E-ring Washer O-ring Footrest pin Apply grease. Do not reuse. ...

Specifications
Tightening torque specifications Note the specified tightening torque is described in the following. “Body frame construction”  “front footrest bracket construction”  “si ...

Other materials:

Precautions
Precautions for clutch system Refer to “general precautions” in section 00 (page 00-1). Schematic and routing diagram Clutch cable routing diagram Refer to “throttle cable routing diagram” in section 1d . Diagnostic information and procedures Clutch system symptom diagnosis ...

Specifications
Service data Brake unit: mm (in) Tightening torque specifications Note the specified tightening torque is described in the following. “Front brake components” Reference: for the tightening torque of fastener not specified in this section, refer to “tightening torq ...

Fail-safe function table
Fi system is provided with fail-safe function to allow the engine to start and the motorcycle to run in a minimum performance necessary even under malfunction condition. The engine can start and can run even if the signal in the table is not received from each sensor. But, the engine ...

© 2011-2026 Copyright www.suzukigsxr.org