Suzuki GSX-R 1000 Service Manual: Clamp
- Clamp the wire harness at such positions as indicated in “wiring harness routing diagram” in section 9a .
- Bend the clamp properly so that the wire harness is clamped securely.
- In clamping the wire harness, use care not to allow it to hang down.
- Do not use wire or any other substitute for the band type clamp.
Electrical parts connector / coupler
Faulty fi system is often related to poor electrical
contact of connector/coupler. Before servicing
individual electronic part, check electrical contact of
the connector/coupler.
When conne ...
Fuse
When a fuse is blown, always investigate the cause to
correct it and then replace the fuse.
Do not use a fuse of different capacity.
Do not use wire or any other substitute for th ...
Other materials:
Country and area codes
The following codes stand for the applicable country(-ies) and area(-s).
Wire color symbols
Warning, caution and information labels location
Noise label
Information label
Vacuum hose routing label
Fuel information label
Manual notice label
Screen la ...
Wiring harness routing diagram
Wiring harness no. 2
Tapping clamp
: insert the clamp from the front side. Place the turn signal
and position light couplers in front of the clamp.
Steel clamp
: clamp the wiring harness at the blue taping point. Bend
the steel clamps to the front side.
...
Diagnostic information and procedures
Engine lubrication symptom diagnosis
Oil pressure check
Check the engine oil pressure periodically. This will give
a good indication of the condition of the moving parts.
Note
before checking the oil pressure, check the
following.
Oil level (refer to “engine oil and fi ...