Recommended service material
Special tool
Water pump construction
Impeller
Mechanical seal
Oil seal
O-ring
O-ring
8
N·m (0.8 Kgf-m, 6.0 Lbf-ft)
10 N·m
(1.0 Kgf-m, 7.0 Lbf-ft)
Apply grease.
Apply engine coolant.
Apply molybdenum oil
solution.
Do not reuse.
...
Heated oxygen sensor (ho2s) removal and
installation
Removal
Do not
remove the ho2 sensor while it is hot.
Caution
be careful not to expose the ho2 sensor to
excessive shock.
Do not use an impact wrench when
removing or installing the ho2 sensor.
Be careful not to twist or damage t ...
Regulator / rectifier inspection
Inspect the regulator/rectifier in the following procedures:
turn the ignition switch off.
Disconnect the regulator/rectifier couplers. Refer to “regulator /
rectifier removal and installation” .
Measure the voltage between the terminals using the multi-circuit
tester ...