Service data
Electrical unit: mm

| Caution never use anything except the specified battery. |
Tightening torque specifications

| Note the specified tightening torque is described in the following. “Regulator / rectifier construction” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Battery visual inspection
Special tools and equipmentWater pump construction
Impeller
Mechanical seal
Oil seal
O-ring
O-ring
8
N·m (0.8 Kgf-m, 6.0 Lbf-ft)
10 N·m
(1.0 Kgf-m, 7.0 Lbf-ft)
Apply grease.
Apply engine coolant.
Apply molybdenum oil
solution.
Do not reuse.
...
Oil pressure regulator / oil strainer
inspection
Refer to “oil pan / oil pressure regulator / oil strainer removal and
installation” .
Oil pressure regulator
Inspect the operation of the oil pressure regulator by
pushing the piston with a proper bar.
If the piston does not operate smoothly, replace the oil
pressure regulator with a new on ...
Short circuit check (wire harness to ground)
Disconnect the negative (–) cable from the battery.
Disconnect the connectors/couplers at both ends of
the circuit to be checked.
Note
if the circuit to be checked branches to other
parts as shown, disconnect all connectors/
couplers of those parts. Otherwise, diagnos ...