Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Fi sensors
Tightening torque specifications
| Note the specified tightening torque is described in the following. “Exhaust control system construction” “exhaust system components” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Exhaust system inspection
Inspect the exhaust pipe, muffler chamber and muffler
connection for exhaust gas leakage and mounting
condition. If any defect is found, replace the exhaust
pipe, muffler chamber or muffler with a ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Exhaust system components”
Special tool
...
Other materials:
DTC “c29” (p1654-h/l): secondary throttle
position sensor (stps) circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C29
Output voltage is not within the following
range.
Difference between actual throttle opening
and opening calculated by ecm is larger
than specified value.
0.15 V ≤ Sensor ...
Clutch parts inspection
Refer to “clutch removal” and “clutch installation” .
Clutch drive and driven plate
Note
wipe off the engine oil from the drive and
driven plates with a clean rag.
Measure the thickness of drive plates with a vernier
calipers. If the drive plate thickness is found to have ...
Thermostat removal and installation
Removal
Drain a small amount of engine coolant. Refer to “cooling system
inspection” in section 0b .
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the thermostat cover (1).
Remove the thermostat ( ...