The standard settings of both front and rear suspensions are selected to meet various riding conditions such as low to high motorcycle speed and light to heavy load on the motorcycle.
The suspension settings can be adjusted for your preference and fine-tuning.
Side stand
Front suspensionInjection timing description
Injection time (injection volume)
The factors to determine the injection time include the basic fuel injection
time, which is calculated on the basis of the
intake air pressure, engine speed and throttle opening angle, and various
compensations. These compensations are
determined according to ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Starter motor components”
Special tool
...
Balancer shaft journal bearing inspection
and selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Selection
Place the plastigauge axial ...