Isc valve preset and opening initialization
When removing or replacing the isc valve, set the isc
valve to the following procedures:
turn the ignition switch on.
Set up the sds tool. (Refer to the sds operation
manual for further details.)
Click the “active control”.
Click the “isc learned value reset” (1) ...
Water pump disassembly and assembly
Refer to “water pump removal and installation” .
Disassembly
Remove the air bleeder bolt (1) if necessary.
Remove the water pump case screws.
Remove the o-ring (2).
Hold the impeller (3) with water pump pliers and
remove the impeller securing bolt (4).
Remove t ...
Conrod crank pin bearing inspection and
selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Place the plastigauge axially along ...