The addition of unsuitable accessories can lead to unsafe operating conditions. It is not possible for suzuki to test each accessory on the market or combinations of all the available accessories; however, your dealer can assist you in selecting quality accessories and installing them correctly. Use extreme caution when selecting and installing the accessories on your motorcycle and consult your suzuki dealer if you have any questions.
Warning
Use suzuki genuine accessories or equivalent, designed and tested for your motorcycle. Follow the guidelines in this section. |
Accessory installation
guidelineFront brake light switch inspection
Inspect the front brake light switch in the following
procedures:
disconnect the front brake light switch coupler (1).
Inspect the front brake light switch for continuity with
the tester.
If any abnormality is found, replace the front brake light switch with a new
one. Re ...
Starter motor runs but does not crank the
engine
The starter motor runs when the transmission is in neutral, but does not run
when the transmission is in any position
other than neutral, with the side-stand up.
Step
Action
Yes
No
1
Check the side-stand switch. Refer to “side-stand / ignition
inte ...
Iat sensor inspection
Refer to “dtc “c21” (p0110-h/l): iat sensor circuit malfunction” in section
1a .
Inspect the iat sensor.
Note
iat sensor resistance measurement method
is the same way as that of the ect sensor.
Refer to “ect sensor inspection” (page 1c-
4).
Caution
& ...