Suzuki GSX-R 1000 Owners Manual: Fuel supply check
If the fuel injection indicator displays "fi", showing signs of trouble in the fuel injection system, take your machine to an authorized suzuki dealer. Refer to the "instrument panel:' section for fuel injection system indicator explanation. If the indicator does not display "fi", make sure there is enough fuel in the fuel tank. If the indicator does not display "fi" and there is enough fuel, ignition system should be checked.
Troubleshooting
This troubleshooting guide is provided
to help you find the cause of
some common complaints.
Caution
Failure to troubleshoot a problem
correctly can damage your
motorcycle. Impr ...
Ignition system check
Remove the spark plugs and
reattach them to the spark
plug caps.
Put the engine stop switch in
the "" position and ignition
switch in the "on" position.
Whil ...
Other materials:
Starter motor removal and installation
Removal
Turn the ignition switch off and disconnect the
battery (–) lead wire (1).
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the starter motor lead wire (2).
Remove the starter motor (3).
...
Using the testers
Incorrectly connecting the (+) and (.) Probes may
cause the inside of the tester to be burned.
If the voltage and current are not known, make
measurements using the highest range.
When measuring the resistance with the multi-circuit
tester (1), ∞ will be shown as 10.00 ...
DTC “c46” (p1657-h/l or p1658): excv
actuator circuit malfunction
Detected condition
Possible cause
C46
The operation signal does not reach the
excv actuator.
Excva position sensor voltage low or
high
0.14 V ≤ Sensor voltage < 4.9 V
(without the above range)
excva can not operate properly.
Excva ...