Wiring systems
Wiring diagramClutch lever position switch inspection
Inspect the clutch lever position switch in the following
procedures:
disconnect the clutch lever position switch lead
wires (1).
Inspect the clutch lever position switch for continuity
with the tester.
If any abnormality is found, replace the switch with a
new one.
S ...
Immobilizer description (for e-02, 19, 24, 51)
The immobilizer, an anti-theft system, is installed as a
standard equipment.
The immobilizer verifies that the key id agrees with ecm
id by means of radio communication through the
immobilizer antenna. When the id agreement is verified,
the system makes the engine ready to start.
...
Rear brake master cylinder components
Reservoir cap
Plate
Diaphragm
Reservoir tank
Reservoir hose
Brake hose
Brake hose union bolt
Brake hose connector
Master cylinder
Spring
Piston/cup set
Push rod
Dust boot
23 N·m (2.3 Kgf-m,
16.5 Lbf-ft)
10 N·m
...