Suzuki GSX-R 1000 Owners Manual: Seat lock and helmet holders
Rear brake pedal
Depressing the rear brake pedal
will apply the rear disk brake. The
brake light will be illuminated
when the rear brake is operated. ...
Front seat
To remove the front seat.
Remove the bolts 1 (right and
left).
Raise the front end of the seat
and slide it forward.
To reinstall the seat, slide the seat
hooks into the se ...
Other materials:
Front suspension adjustment
After installing the front fork, adjust the spring pre-load
and two kinds of damping force as follows:
Adjust the
left and right front forks to the
same setting.
Spring pre-load adjustment
Turn the spring pre-load adjuster (1) counterclockwise
fully. From that position (softe ...
Tp sensor adjustment
Inspect the tp sensor setting position and adjust it if
necessary in the following procedures:
connect the special tool (mode select switch) to the dealer mode
coupler. Refer to “self-diagnostic procedures” in section 1a .
Special tool
: 09930–82720 (mode selection switch)
Warn ...
Front wheel assembly removal and installation
Removal
Remove the brake calipers, left and right.
Caution
do not operate the brake lever with the
caliper removed.
Loosen two axle pinch bolts (1) on the right front fork
leg.
Remove the front axle bolt (2).
Raise the front wheel off the ground a ...