To remove the front seat.


To reinstall the seat, slide the seat hooks into the seat hook retainers on the frame and tighten the bolts securely.
Warning
Fasten the seat securely in its proper position. |
Rear seatSide-stand removal and installation
Removal
Support the motorcycle with a jack or wooden block.
Caution
do not support the motorcycle with the exhaust pipes.
Make sure that the motorcycle is supported securely.
Remove the side-stand as shown in the side-stand construction.
Refer to ...
Oil pressure switch inspection
Inspect the oil pressure switch in the following
procedures:
Note
before inspecting the oil pressure switch, check if the engine oil level
is correct. Refer to “engine oil and filter replacement” in section 0b .
Remove the left side cowling. Refer to “exterior parts removal ...
DTC “c15” (p0115-h/l): ect sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C15
Output voltage is not with in the following
range.
0.15 V ≤ Sensor voltage < 4.85 V
Ect sensor circuit open or short.
Ect sensor malfunction.
Ec ...