Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Oil pump
Oil
Tightening torque specifications
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Oil pump inspection
Inspect the oil pump in the following procedures:
remove the oil pump. Refer to “oil pump removal and installation” .
Rotate the oil pump by hand and check that it moves
smoothly. ...
Special tools and equipment
Recommended service material
Special tool
...
Other materials:
Chassis bolt and nut inspection
Tighten chassis bolt and nut
initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Check that all chassis bolts and nuts are tightened to
their specified torque.
Steering stem
lock-nut 80 n·m (8.0 Kgf-m, 58.0 Lbf-ft)
Stee ...
Drive chain replacement
Use the special tool in the following procedures, to cut
and rejoin the drive chain.
Note
when using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
Special tool
: 09922–22711 (drive chain cutting
and joint
tool set)
Driv ...
Fail-safe function table
Fi system is provided with fail-safe function to allow the engine to start
and the motorcycle to run in a minimum
performance necessary even under malfunction condition.
The engine can start and can run even if the signal in the table is not
received from each sensor. But, the engine
...