Service data
Electrical unit: mm (in)

Tightening torque specifications

Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Drive mode selector inspection
Special tools and equipmentAp sensor removal and installation
Removal
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the starter relay (1) from the holder.
Disconnect the coupler (2) and remove the ap
sensor (3).
Installation
Install the ap sensor in the rever ...
DTC “c91” (p0500): vehicle speed sensor
circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Speedometer does not receive signal from the vehicle
speed sensor for more than 6 sec. When the motorcycle is
running. Ecm does not receive signal from the vehicle
speed sensor for more than ...
Front brake disc removal and installation
Removal
Remove the front wheel assembly. Refer to “front wheel assembly removal
and installation” in section 2d .
Remove the front brake disc.
Installation
Install the front brake disc in the reverse order of
removal. Pay attention to the following points:
make sure ...