Toyota RAV4 manuals

Suzuki GSX-R 1000 Owners Manual: Starting the engine

Before attempting to start the engine, make sure:

  1.  The transmission is in neutral.
  2.  The engine stop switch is in the "" position.

Note

: this motorcycle has a starter interlock system for the ignition and starter circuit. The engine can only be started if:

When the engine is cold:

  1. Close the throttle completely and push the electric starter button.
  2.  After the engine starts, let the engine run until the engine sufficiently warms up.

When the cold engine is hard to start:

  1. Open the throttle approximately 1/8 turn and push the electric starter button.
  2.  After the engine starts, let the engine run until the engine sufficiently warms up.

When the engine is warm:

Close the throttle completely and push the electric starter button.

When the warm engine is hard to start:

  1. Open the throttle approximately 1/8 turn.
  2.  Push the electric starter button.
Warning


Running the engine indoors or in a garage can be hazardous.

Exhaust gas contains carbon monoxide, a gas that is colorless and odorless and can cause death or severe injury.

Only run the engine outdoors where there is fresh air.

 

Caution

Running the engine too long without riding may cause the engine to overheat. Overheating can result in damage to internal engine components and discoloration of exhaust pipes.

Shut the engine off if you cannot begin your ride promptly.

Riding tips
...

Starting off
Warning Riding this motorcycle at excessive speed increases your chances of losing control of the motorcycle. This may result in an accident. Always ride within the limits of ...

Other materials:

Gearshift lever height inspection and adjustment
Inspect and adjust the gearshift lever height in the following procedures:  inspect the gearshift lever height “a” between the lever top and footrest. Adjust the gearshift lever height if necessary. Gearshift lever height “a” standard: 65 – 75 mm (2.6 – 3.0 In) Loosen the l ...

Evaporative emission control system removal and installation (only for e-33)
Hose removal Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).  Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d .  Remove the evap hoses as shown in the evap canister h ...

Rear wheel related parts inspection
Refer to “rear wheel assembly removal and installation” . Tire Refer to “tire inspection” in section 0b . Rear brake disc Refer to “rear brake disc inspection” in section 4c . Wheel damper Refer to “drive chain related parts inspection” in section 3a . Sprocket Refer to “drive chain ...

© 2011-2026 Copyright www.suzukigsxr.org