Toyota RAV4 manuals

Suzuki GSX-R 1000 Owners Manual: Storage procedure and motorcycle cleaning

Suzuki GSX-R 1000 Owners Manual / Storage procedure and motorcycle cleaning

Ignition system check
Remove the spark plugs and reattach them to the spark plug caps. Put the engine stop switch in the "" position and ignition switch in the "on" position. Whil ...

Storage procedure
If your motorcycle is to be left unused for an extended period of time, it needs special servicing requiring appropriate materials, equipment and skill. For this reason, suzuki recommends that yo ...

Other materials:

Throttle cable play inspection and adjustment
Inspect throttle cable play initially at 1 000 km (600 miles, 2 months) and every 6 000 km (4 000 miles, 12 months) thereafter Inspect and adjust the throttle cable play “a” as follows: Throttle cable play “a” 2.0 – 4.0 Mm (0.08 – 0.16 In) Remove the boot (1).  Loosen the lock-nu ...

Rear wheel assembly removal and installation
Removal Loosen the axle nut (1).  Raise the rear wheel off the ground and support the motorcycle with a jack or wooden block. Caution make sure that the motorcycle is supported securely. Remove the axle nut (1).  Loosen the left and right lock-nuts (2) an ...

Swingarm bearing removal and installation
Removal Remove the swingarm. Refer to “swingarm removal and installation” .  Remove the swingarm pivot bearings (1) using the special tool. Special tool (a): 09921–20240 (bearing remover set) Remove the center spacer (2). Remove the cushion lever bearing (3) usin ...

© 2011-2026 Copyright www.suzukigsxr.org