Suzuki GSX-R 1000 Owners Manual: Windshield cleaning
Clean the windshield with soft cloth and warm water with mild detergent. If scratched, polish with a commercially available plastic polish. Replace the windshield if it becomes scratched or discolored so as to obstruct view.
When replacing the windshield, use suzuki replacement windshield.
|
Caution Cleaning with any alkaline or strong acid cleaner, gasoline, brake fluid, or any other sol· vent will damage the wind· shield. Clean only with a soft cloth and warm water with mild deter· gent. |
Waxing the motorcycle
After washing the motorcycle, waxing is recommended to further protect and beautify the paint.
Observe the precautions specified by the wax manufacturer.
Washing the motorcycle
When washing the motorcycle,
follow the instructions below:
Remove dirt and mud from the
motorcycle with running water.
You may use a soft sponge or
brush. Do not use hard materials
...
Inspection after cleaning
For extended life of your motorcycle,
lubricate according to "general
lubrication" section .
Warning
Wet brakes can cause poor
braking performance and may
lead to an accid ...
Other materials:
Starter button inspection
Inspect the starter button in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the right handlebar switch coupler (1).
Inspect the starter button for continuity with the
tester.
If ...
Piston ring removal and installation
Removal
Remove the piston. Refer to “engine bottom side disassembly” .
Carefully spread the ring opening with your thumbs
and then push up the opposite side of the 1st ring to
remove it.
Note
do not expand the piston ring excessively
since it is apt to be broken down. ...
Water pump components
Impeller
Mechanical seal
Oil seal
O-ring
O-ring
8
N·m (0.8 Kgf-n, 6.0 Ib-ft)
10 N·m
(1.0 Kgf-n, 7.0 Ib-ft)
6 N·m (0.6
Kgf-n, 4.5 Ib-ft)
13 N·m
(1.3 Kgf-n, 9.5 Ib-ft)
Apply grease.
Apply engine coolant.
Apply molyb ...