
|
Headlight removal and installationClutch lever position switch inspection
Inspect the clutch lever position switch in the following
procedures:
disconnect the clutch lever position switch lead
wires (1).
Inspect the clutch lever position switch for continuity
with the tester.
If any abnormality is found, replace the switch with a
new one.
S ...
Precautions
Precautions for driveline / axle
Refer to “general precautions” in section 00 (page 00-1).
Never inspect or
adjust the drive chain while the engine is running.
Caution
do not use trichloroethylene, gasoline or such similar
solvent. These fluids will d ...
DTC table
In the lcd (display) panel, the malfunction code is indicated from small code
to large code.
*1 To get the proper signal from the throttle position sensor, the sensor basic
position is indicated in the lcd
(display) panel. The malfunction code is indicated in three digits. In front o ...