Suzuki GSX-R 1000 Service Manual: Repair instructions
- Headlight components
- Headlight removal and installation
- Headlight bulb and position light bulb replacement
- Headlight beam adjustment
- Front turn signal light components
- Front turn signal light removal and installation
- Front turn signal light bulb replacement
- Rear lighting system construction
- Rear combination light removal and installation
- License plate light components
- License plate light removal and installation
- License plate light bulb replacement
- Rear turn signal light components
- Rear turn signal light removal and installation
- Rear turn signal light bulb replacement
- Reflex reflector construction
- Turn signal / side-stand relay inspection
- Turn signal / side-stand relay removal and installation
- Hazard switch inspection
- Turn signal switch inspection
- Dimmer / passing light switch inspection
Lighting systems
...
Headlight components
Headlight low beam bulb (12 v 55 w, h11)
Headlight high beam bulb (12 v 65 w, h9)
Position light bulb (12 v 5 w) x 2
...
Other materials:
Self-diagnostic procedures
Use of mode select switch
Note
do not disconnect the coupler from ecm,
battery cable from battery, ecm ground
wire from engine or main fuse before
confirming dtc (diagnostic trouble code)
stored in memory. Such disconnection
may erase memorized information in ec ...
Throttle body components
Fuel delivery pipe
Fuel delivery pipe t-joint
O-ring
Tp sensor
Stp sensor
Secondary fuel injector
Primary fuel injector
Cushion seal
Isc valve
Air screw
Vacuum hose
Evap system purge control solenoid valve
For e-33 only
3.5
...
Heated oxygen sensor (ho2s) removal and
installation
Removal
Do not
remove the ho2 sensor while it is hot.
Caution
be careful not to expose the ho2 sensor to
excessive shock.
Do not use an impact wrench when
removing or installing the ho2 sensor.
Be careful not to twist or damage t ...