Suzuki GSX-R 1000 Service Manual: Oil jet inspection
Refer to “oil jet removal and installation” .
Oil jet
Make sure that the oil jets are not clogged. If they are clogged, clean their oil passage using a wire of the proper size and compressed air.
|
Oil jet removal and installation
Piston cooling oil jet
Removal
Remove the engine assembly. Refer to “engine assembly removal” in
section 1d .
Remove the crankshaft assembly. Refer to “engine
bottom side disassembly ...
Oil pump removal and installation
Note
be careful not to drop any parts into the
crankcase.
Removal
Remove the oil pan, oil pressure regulator and oil strainer. Refer to
“oil pan / oil pressure regulator / oi ...
Other materials:
Front fork disassembly and assembly
Refer to “front fork removal and installation” (page 2b-
2).
Note
the right and left front forks are installed
symmetrically and therefore the disassembly
procedure for one side is the same as that for
the other side.
Disassembly
Turn the spring pre-load adjuster (1) t ...
Engine bottom side assembly
Assemble the engine bottom side in the reverse order of
disassembly. Pay attention to the following points:
Note
apply engine oil to each running and sliding
part before reassembling.
Breather oil return plate
When installing the breather oil return plate (1), apply
thread loc ...
Conrod crank pin bearing removal and
installation
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Removal
Remove the conrod crank pin bearings (1).
Note
do not remove the bearings (1) unless
absolutely necessary.
Make a note of where the bearings are
removed ...