Suzuki GSX-R 1000 Service Manual: Oil pressure indicator inspection
Inspect the oil pressure indicator in the following procedures:
| Note before inspecting the oil pressure switch, check if the engine oil level is correct. Refer to “engine oil and filter replacement” in section 0b . |
- Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Disconnect the oil pressure switch lead wire (1) from the oil pressure switch.
- Turn the ignition switch on.
- Check if the oil pressure indicator (led) (2) will light
up and lcd (3) will flicker when grounding the lead
wire (1).
If the oil pressure indicator does not light up, replace the combination meter assembly with a new one after checking the connection of couplers.
Oil pressure switch removal and installation
Refer to “oil pressure switch removal and installation” in section 1e .
Speed sensor inspection
Inspect the speed sensor in the following procedures:
remove the speed sensor. Refer to “speed sensor removal and
installation” .
Connect a 12 v battery (between b and b/w), 10 k& ...
Oil pressure switch inspection
Inspect the oil pressure switch in the following
procedures:
Note
before inspecting the oil pressure switch, check if the engine oil level
is correct. Refer to “engine oil and filter r ...
Other materials:
Conclusion
Traffic, road and weather conditions
vary. Other motorists'
actions are unpredictable. Your
motorcycle's condition can
change. These factors can best
be dealt with by giving every ride
your full attention.
Circumstances beyond your control
could lead to an accident. You
need to prepare fo ...
Balancer shaft disassembly and assembly
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Disassembly
Remove the balancer shaft. Refer to “engine bottom side disassembly” .
Remove the washers, balancer gear and dampers
from the shaft.
Assembly
Assembly is in the re ...
Starter relay removal and installation
Removal
Turn the ignition switch off.
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the battery (–) lead wire (1) from the
battery.
Remove the starter relay cover (2) and disconnect
the starter rel ...