Suzuki GSX-R 1000 Service Manual: Rear brake pedal removal and installation
Removal
- Remove the master cylinder assembly. Refer to “rear brake master cylinder assembly removal and installation” .
- Disconnect the rear brake light switch lead wire coupler. Refer to “rear brake light switch inspection” .
- Remove the rear brake pedal as shown in the rear brake pedal construction. Refer to “rear brake pedal construction” .
Installation
| Caution replace the snap ring with a new one. |
Install the rear brake pedal as shown in the rear brake pedal construction. Refer to “rear brake pedal construction” .
Rear brake pedal construction
Footrest bracket no. 2
Footrest bracket no. 1
Rear brake peda
Footrest holder
Footrest
35 N·m (3.5 Kgf-m,
25.5 Lbf-ft)
23 N·m
(2.3 Kgf-m, 16. ...
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front brake hose routing diagram” ...
Other materials:
Injection timing description
Injection time (injection volume)
The factors to determine the injection time include the basic fuel injection
time, which is calculated on the basis of the
intake air pressure, engine speed and throttle opening angle, and various
compensations. These compensations are
determined according to ...
DTC “c15” (p0115-h/l): ect sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C15
Output voltage is not with in the following
range.
0.15 V ≤ Sensor voltage < 4.85 V
Ect sensor circuit open or short.
Ect sensor malfunction.
Ec ...
Front brake caliper disassembly and
assembly
Refer to “front brake caliper removal and installation” .
Note
the right and left calipers are installed
symmetrically and therefore the disassembly
procedure for one side is the same as that for
the other side.
Disassembly
Remove the brake pads (1) and spring from the
...