Suzuki GSX-R 1000 Service Manual: Repair instructions
Brake pedal height inspection and adjustment
Refer to “brake system inspection” in section 0b .
- Front brake light switch inspection
- Rear brake light switch inspection
- Rear brake light switch inspection and adjustment
- Air bleeding from brake fluid circuit
- Brake fluid replacement
- Front brake hose removal and installation
- Rear brake hose removal and installation
- Front brake master cylinder components
- Front brake master cylinder assembly removal and installation
- Front brake master cylinder / brake lever disassembly and assembly
- Front brake master cylinder parts inspection
- Rear brake master cylinder components
- Rear brake master cylinder assembly removal and installation
- Rear brake master cylinder disassembly and assembly
- Rear brake master cylinder parts inspection
- Rear brake pedal construction
- Rear brake pedal removal and installation
Diagnostic information and procedures
Brake symptom diagnosis
...
Front brake light switch inspection
Inspect the front brake light switch in the following
procedures:
disconnect the front brake light switch coupler (1).
Inspect the front brake light switch for continuity with
t ...
Other materials:
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Water hose routing diagram” “water pump components” “water
pump construction”
Special tool
...
Exhaust control system construction
Excv cable no. 1 (Cl)
Excv cable no. 2 (Op)
When
loosening or tightening the pulley bolt, be sure to fix the
pulley with an adjustable wrench, or excva may get damaged.
5 N·m (0.5 Kgf-m, 3.5 Lbf-ft)
42 – 43 Mm (1.65 – 1.69 In)
60 – 61 Mm (2.36 – ...
Turn signal light
To replace the turn signal light
bulb, follow these directions.
Remove screw and take off
the lens.
Turn the socket counterclockwise
and remove it.
Push in the bulb and turn it
counterclockwise.
Caution
Overtightening the screws may
cause the le ...