When replacing the throttle body assembly or tp sensor with a new one or reinstalling the tp sensor, reset the tp learned value in the following procedures:
| Note keep the throttle valves fully closed while resetting the tp learned value. |


| Note the leaned value of the tp sensor is set at preset position. |

Isc valve reset
Engine assembly removalCamshaft inspection
Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Camshaft identification
The exhaust camshaft has the embossed letters “ex”
and the intake camshaft has the embossed letters “in”.
Cam wear
Check the camshaft for wear or damage.
Measure the cam height “a” w ...
Water pump related parts inspection
Refer to “water pump disassembly and assembly” .
Mechanical seal
Visually inspect the mechanical seal for damage, with
particular attention given to the sealing face.
Replace the mechanical seal that shows indications of
leakage.
Oil seal
Visually inspect the oil seal for damage, with p ...
Evaporative emission control system
inspection (only for e-33)
Refer to “evaporative emission control system removal and installation (only
for e-33)” .
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
Note
make sure that the hoses are securely
connected.
Evap canister
Inspect the eva ...