Injection timing descriptionModification
Modification of the motorcycle, or
removal of original equipment
may render the vehicle unsafe or
illegal. Obey all applicable equipment
regulations in your area.
The frame of this motorcycle is
made of an aluminum alloy.
Therefore, never make any modifications
such as drilling or weldin ...
Conrod crank pin bearing inspection and
selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Place the plastigauge axially along ...
Handlebar removal and installation
Removal
Remove the following parts from the left handlebar.
left handlebar switch box (1)
handlebar balancer (2)
grip rubber (3)
clutch cable (4)
Remove the following parts from the right handlebar.
right handlebar switch box (5)
...