Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Wheel unit: mm (in)
Tire
Tightening torque specifications
| Note the specified tightening torque is described in the following. “Front wheel components” “front wheel assembly construction” “rear wheel components” “rear wheel assembly construction” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Wheel balance check and adjustment
Check and adjust the wheel balance in the following
procedures:
removal the wheel assembly. Refer to “front wheel assembly removal and
installation” and “rear wheel assembly remova ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Front wheel components” “front wheel assembly construction” “rear
wheel compone ...
Other materials:
Starter torque limiter removal and
installation
Removal
Remove the clutch assembly. Refer to “clutch removal” in section 5c .
Remove the washer (1), starter idle gear no. 1 (2)
And starter torque limiter (3).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
apply ...
Rear brake hose routing diagram
Hose clamp
: face the clamp end backward.
Stopper
: after the brake hose union has contacted
to the stopper, tighten the union bolt.
Brake pad pin
Plug
Caliper sliding pin b
Caliper sliding pin a
White marking
Yellow marking
Pass the
...
Handlebar removal and installation
Removal
Remove the following parts from the left handlebar.
left handlebar switch box (1)
handlebar balancer (2)
grip rubber (3)
clutch cable (4)
Remove the following parts from the right handlebar.
right handlebar switch box (5)
...