Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Electrical
Tightening torque specifications
| Note the specified tightening torque is described in the following. “Wiring harness routing diagram” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Special tools and equipment
Recommended service material
| Note required service material is also described in the following. “Wiring harness routing diagram” |
Wiring harness routing diagram
Wiring harness no. 2
Tapping clamp
: insert the clamp from the front side. Place the turn signal
and position light couplers in front of the clamp.
Steel clamp
...
Lighting systems
...
Other materials:
Front fork disassembly and assembly
Refer to “front fork removal and installation” (page 2b-
2).
Note
the right and left front forks are installed
symmetrically and therefore the disassembly
procedure for one side is the same as that for
the other side.
Disassembly
Turn the spring pre-load adjuster (1) t ...
Rear brake hose routing diagram
Hose clamp
: face the clamp end backward.
Stopper
: after the brake hose union has contacted
to the stopper, tighten the union bolt.
Brake pad pin
Plug
Caliper sliding pin b
Caliper sliding pin a
White marking
Yellow marking
Pass the
...
Crankshaft thrust clearance inspection and
selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
With the crankshaft’s right-side and left-side thrust
bearings inserted into the upper crankcase.
Measure the thrust clearance “a” between the leftside
thrust bearing and ...