Suzuki GSX-R 1000 Service Manual: Cushion lever inspection
Refer to “cushion lever removal and installation” .
Cushion lever
Inspect the cushion levers for damage. If any defects are found, replace the cushion levers with new ones.
Cushion lever removal and installation
Removal
Remove the right side cowling and side frame covers. Refer to “exterior
parts removal and installation” in section 9d .
Support the motorcycle with a jack to relieve load on
t ...
Cushion rod removal and installation
Removal
Remove the right side cowling and side frame covers. Refer to “exterior
parts removal and installation” in section 9d .
Support the motorcycle with a jack to relieve load on
t ...
Other materials:
Starter motor runs but does not crank the
engine
The starter motor runs when the transmission is in neutral, but does not run
when the transmission is in any position
other than neutral, with the side-stand up.
Step
Action
Yes
No
1
Check the side-stand switch. Refer to “side-stand / ignition
inte ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Front fork components”
Special tool
...
DTC “c41” (p2505): ecm power input signal
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41/P2505
No voltage is applied to the ecm.
Lead wire/coupler connection of ecm terminal to fuel
fuse.
Fuel fuse.
Wiring diagram
Troubleshooting
C ...