Turn the ignition switch on and check that the fuel pump operates for a few seconds.
If the fuel pump motor does not make operating sound, inspect the fuel pump circuit connections or inspect the fuel pump relay and to sensor. Refer to “fuel pump relay inspection” and “dtc “c23” (p1651- h/l): to sensor circuit malfunction” in section 1a .
If the fuel pump relay, to sensor and fuel pump circuit connections are ok, the fuel pump may be faulty, replace the fuel pump with a new one. Refer to “fuel pump disassembly and assembly” .
Fuel pressure inspection
Fuel discharge amount inspectionSpecifications
Service data
Clutch
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Clutch control system components” “clutch components”
Reference: for the tightening torque of fastener not specified in this ...
Front brake master cylinder / brake lever disassembly and assembly
Refer to “front brake master cylinder assembly removal and installation” .
Disassembly
Remove the reservoir cap (1), plate (2), diaphragm
(3) and reservoir tank (4).
Remove the brake light switch (5) and brake lever
(6).
Remove the dust boot (7) and push rod (8).
  ...
Spring pre-load adjustment
To change the spring pre-load,
turn the adjuster 1 clockwise or
counterclockwise. Turning the
adjuster clockwise will increase
the spring pre-load. Turning the
adjuster counterclockwise will
decrease the spring pre-load.
There are five grooved lines on
the side of the adjuster 1 for re ...