Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Pair system hose routing diagram

Suzuki GSX-R. Pair system hose routing diagram


  1. Pair control solenoid valve
  2. Pair reed valve
  3. White marking (hidden side)
  4. Yellow marking
  5. Blue marking
  6. Red marking
  7. Face the
    clamp end to the top.
  8. Make sure
    the clamp is not contacted to the frame or air cleaner box.
  9. 90°
  10. 45°
  11. 15°
Schematic and routing diagram
...

Evap canister hose routing diagram (only for e-33)
Evap system purge control solenoid valve Surge hose Purge hose Fuel shut-off valve Rear fender Evap canister Seat hook White marking Yellow marking ...

Other materials:

Oil pump inspection
Inspect the oil pump in the following procedures:  remove the oil pump. Refer to “oil pump removal and installation” .  Rotate the oil pump by hand and check that it moves smoothly. If it does not move smoothly, replace the oil pump assembly. Caution do not attempt t ...

Conrod crank pin bearing inspection and selection
Refer to “engine bottom side disassembly” (page 1d- 49). Refer to “engine bottom side assembly” . Inspection Inspect the bearing surfaces for any signs of fusion, pitting, burn or flaws. If any, replace them with a specified set of bearings. Place the plastigauge axially along ...

Tampering with noise control system prohibited
Federal law prohibits the following acts or the causing there of;  The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement, of any device or element of ·design incorporated into any new vehicle for the purpose of noise ...

© 2011-2025 Copyright www.suzukigsxr.org