Precautions
Precautions for emission control devices
Refer to “general precautions” in section 00 (page 00-1).
Special tools and equipmentStarter torque limiter inspection
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the washers (1), starter idle gear no. 1 (2)
And no. 2 (3).
Remove the starter idle gear no. 2 Bearing (4), shaft
(5) and washer (6).
Hold the starter clutch with the special tool an ...
Tightening torque list
Engine
Fi system + intake air system
Cooling system
Chassis
Tightening torque chart
For other bolts and nuts not listed in the preceding page, refer to this
chart:
Conventional bolt
“4” Marked bolt
“7” Marked bolt
...
Cushion rod bearing removal and installation
Removal
Remove the cushion rod. Refer to “cushion rod removal and installation”
.
Remove the cushion rod bearing with the special
tool.
Special tool
(a):
09921–20240 (bearing remover set)
Installation
Caution
the removed bearings must be replaced with
new on ...