Suzuki GSX-R 1000 Service Manual: Repair instructions

Evap canister hose routing diagram (only for e-33)

Evap system purge control solenoid valve Surge hose Purge hose Fuel shut-off valve Rear fender Evap canister Seat hook White marking Yellow marking ...

Heated oxygen sensor (ho2s) removal and installation

Removal Do not remove the ho2 sensor while it is hot.   Caution  be careful not to expose the ho2 sensor to excessive shock.  Do not use an impact ...

Other materials:

Starter torque limiter removal and installation
Removal Remove the clutch assembly. Refer to “clutch removal” in section 5c .  Remove the washer (1), starter idle gear no. 1 (2) And starter torque limiter (3). Installation Installation is in the reverse order of removal. Pay attention to the following point:  apply ...

Clutch lever position switch inspection
Inspect the clutch lever position switch in the following procedures:  disconnect the clutch lever position switch lead wires (1). Inspect the clutch lever position switch for continuity with the tester. If any abnormality is found, replace the switch with a new one. S ...

Special tools and equipment
Recommended service material Note required service material is also described in the following. “Front brake master cylinder components”  “rear brake master cylinder components”  “rear brake pedal construction” Special tool ...