Inspect the crankcase breather (pcv) hose in the following procedures:
Refer to “fuel tank removal and installation” in section 1g .
If it is worn or damaged, replace the crankcase breather (pcv) hose with a new one.

Pair system inspection
Crankcase breather (pcv) hose / reed
valve / cover removal and installationCylinder head cover related parts
inspection
Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Refer to “cylinder head cover disassembly and assembly” .
Cylinder head cover
Clean and check the gasket grooves “a” and pair reed
valve mating surfaces “b” of the cylinder head cover.
If there is anything unu ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...
Starter torque limiter removal and
installation
Removal
Remove the clutch assembly. Refer to “clutch removal” in section 5c .
Remove the washer (1), starter idle gear no. 1 (2)
And starter torque limiter (3).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
apply ...