Special tools and equip
PrecautionsEcm removal and installation
Removal
Remove the frame covers. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the battery (–) lead wire.
Remove the tool set (1) and prop stay (2).
Disconnect the hose clamp (3) (e-33 only) and
starter relay (4).
Remo ...
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Handlebar components” “steering components” “steering
damper construction”
Reference: for the tightening torque of fastener not specified in this
section ...
Engine oil level check
Check the engine oil level as follows:
Place the motorcycle on level
ground on the side stand.
Start the engine and allow it to
idle for a few minutes.
Stop the engine and wait three
minutes.
Hold the motorcycle vertically
and check the oil level through
...