Suzuki GSX-R 1000 Owners Manual: Drive chain
This motorcycle has a master link type drive chain. We recommend that you take your motorcycle to an authorized suzuki dealer if the drive chain needs replacing.
The condition and adjustment of the drive chain should be checked each day before you ride. Always follow the guidelines for inspecting and servicing the chain.
 Warning
Inspect, adjust, and maintain the chain properly before each ride, according to this section. |
Engine coolant
Coolant level
The engine coolant solution
should be between "f" (full) and
"1..:' (Low) level lines on the engine
coolant reservoir. If the level is
lower than "1..:' (Low ...
Inspecting the drive chain
When inspecting the chain, look
for the following:
loose pins
damaged rollers
dry or rusted links
kinked or binding links
excessive wear
improper chain adj ...
Other materials:
Front fork components
Front fork cap
O-ring
Rebound damping force adjuster rod
Compression damping force adjuster rod
Piston rod nut
O-ring
Piston ring
Rod guide case
Spring
Piston rod
Spring collar b
Spring
Spring collar a
Slide bushing
Outer tu ...
Regulator / rectifier inspection
Inspect the regulator/rectifier in the following procedures:
turn the ignition switch off.
Disconnect the regulator/rectifier couplers. Refer to “regulator /
rectifier removal and installation” .
Measure the voltage between the terminals using the multi-circuit
tester ...
Balancer shaft journal bearing removal and
installation
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Removal
Remove the balancer shaft journal bearings (1).
Note
do not remove the bearings (1) unless
absolutely necessary.
Make a note of where the bearings are
r ...