Suzuki GSX-R 1000 Service Manual: Water hose inspection
Inspect the water hoses in the following procedures:
- remove the side cowlings. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
- Check the water hoses for crack, damage or engine coolant leakage. If any defect is found, replace the water hose with a new one.
- Any leakage from the connecting section should be corrected by proper tightening. Refer to “water hose routing diagram” .
- After finishing the water hoses inspection, reinstall the removed parts.
Radiator / cooling fan motor removal and
installation
Removal
Remove the inner under cowlings. Refer to “exterior parts removal and
installation” in section 9d .
Drain engine coolant. Refer to “cooling system inspection” in section
0b . ...
Water hose removal and installation
Removal
Remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Drain engine coolant. Refer to “cooling system inspection” in section
...
Other materials:
Fuel pump components
Fuel level gauge
Fuel pressure regulator assembly
O-ring
Joint
Fuel pump
Fuel pump case
Fuel mesh filter
10
N·m (1.0 Kgf-m, 7.0 Lbf-ft)
Apply engine oil.
Apply grease.
Do not reuse.
...
Ap sensor removal and installation
Removal
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the starter relay (1) from the holder.
Disconnect the coupler (2) and remove the ap
sensor (3).
Installation
Install the ap sensor in the rever ...
Rear seat
The seat lock is located under the
left frame cover. To remove the
rear seat, insert the ignition key
into the lock and turn it clockwise.
Raise the front end of the seat
and slide it forward.
To reinstall the seat, slide the seat hooks into the seat hook retainers and
push down firm ...