Clean and lubricate drive chain every 1 000 km (600 miles)
Clean and lubricate the drive chain in the following procedures:
Caution
These fluids have too great dissolving power for this chain and they can damage the orings. Use only kerosine to clean the drive chain. |
Caution
|

Drive chain inspection and adjustment
Brake system inspectionDTC “c13” (p0105-h/l): iap sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C13
Iap sensor voltage is not within the
following range.
0.5 V ≤ Sensor voltage < 4.85 V
Note
note that atmospheric pressure
varies depending on weather
c ...
Rear brake pedal construction
Footrest bracket no. 2
Footrest bracket no. 1
Rear brake peda
Footrest holder
Footrest
35 N·m (3.5 Kgf-m,
25.5 Lbf-ft)
23 N·m
(2.3 Kgf-m, 16.5 Lbf-ft)
18 N·m
(1.8 Kgf-m, 13.0 Lbf-ft)
Apply grease.
Apply thread lock to the ...
Gearshift shaft / gearshift cam plate removal
and installation
Removal
Remove the engine sprocket cover. Refer to “engine sprocket removal and
installation” in section 3a .
Remove the clutch components. Refer to “clutch removal” in section 5c .
Remove the snap ring (1) and washer (2) from the
gearshift shaft.
Special tool
: 09900–06 ...