Removal

Installation
Install the turn signal/side-stand relay in the reverse order of removal.
Turn signal / side-stand relay inspection
Hazard switch inspectionAccessory installation
guideline
Install aerodynamic affecting
accessories, such as a fairing,
windshield, backrests, saddlebags,
and travel trunks, as low
as possible, as close to the
motorcycle and as near the
center of gravity as is feasible.
Check that the mounting
brackets and other attachment
hardware are ...
Air cleaner element inspection
Inspect air cleaner element
every 6 000 km (4 000 miles, 12 months)
Inspection
Remove the air cleaner element. Refer to “air cleaner element removal
and installation” in section 1d .
Inspect the air cleaner element for clogging. If it is
clogged with dirt, replace it with a new on ...
Gear position (gp) switch removal and installation
Removal
Turn the ignition switch off.
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the gear position switch lead wire
coupler (1).
Remove the engine sprocket cover. Refer to “engine sprocket r ...