Battery runs down quickly
Battery current leakage inspectionStarter torque limiter inspection
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the washers (1), starter idle gear no. 1 (2)
And no. 2 (3).
Remove the starter idle gear no. 2 Bearing (4), shaft
(5) and washer (6).
Hold the starter clutch with the special tool an ...
Fuel pump components
Fuel level gauge
Fuel pressure regulator assembly
O-ring
Joint
Fuel pump
Fuel pump case
Fuel mesh filter
10
N·m (1.0 Kgf-m, 7.0 Lbf-ft)
Apply engine oil.
Apply grease.
Do not reuse.
...
Front brake caliper disassembly and
assembly
Refer to “front brake caliper removal and installation” .
Note
the right and left calipers are installed
symmetrically and therefore the disassembly
procedure for one side is the same as that for
the other side.
Disassembly
Remove the brake pads (1) and spring from the
...